In plastic injection moulding, achieving the required colour and mechanical performance depends heavily on how pigment is introduced into the base polymer. While masterbatch dosing is a common and cost effective method for colouring standard thermoplastics, high dosage rates can sometimes compromise the structural integrity of sensitive engineering polymers such as polycarbonate.
At CJ Tool & Mouldings, our technical team recently resolved a production challenge where a change in material supply route caused significant processing and quality issues. Working methodically on the shop floor our engineers isolated the root cause and restored consistent production without compromising component quality.
The Production Challenge
A long running component, previously moulded using a pre compounded black polycarbonate, was scheduled for production using a new customer supplied material specification. Instead of the usual compounded grade, the customer supplied a natural polycarbonate base resin alongside a black masterbatch recommended for dosing at 4%.
Once production began, the parts exhibited severe quality and processing issues:
- Components became brittle and failed to maintain expected impact strength.
- Parts began sticking inside the mould tool during ejection.
- The process became unstable, leading to both flashing and short shots.
Root Cause Analysis on the Shop Floor
When processing issues appear following a specification change, isolating variables systematically is essential. Our engineering and moulding teams conducted a controlled trial by running the natural polycarbonate resin without any masterbatch additive.
Running the natural base polymer produced clean, dimensionally stable parts with zero sticking, flash, or brittleness. This confirmed that the base polycarbonate and the mould tool were performing as expected, isolating the 4% black masterbatch dosage as the source of the problem.
Why High Masterbatch Dosage Affects Polycarbonate
Polycarbonate is sensitive to moisture, thermal history, and carrier resins used in colour concentrates. At a 4% let down ratio, the carrier resin and additives within the masterbatch altered the chemical structure and melt viscosity of the polycarbonate during processing.
This degradation softened the polymer melt unpredictably while making the cooled component brittle. Reducing the masterbatch percentage was not viable, as doing so prevented the part from achieving the required deep black visual finish.
The Solution: Returning to a Compounded Material
With the root cause verified through practical trials, we collaborated directly with the customer to review the material specification. We requested remaining stock of the original black compounded polycarbonate so production could continue.
Once the pre compounded black polycarbonate was loaded onto the press, the process stabilised immediately. The entire batch was completed smoothly with consistent mechanical strength, clean ejection, and zero defects.
Key Takeaways for Design Engineers and Buyers
When specifying coloured engineering polymers like polycarbonate, consider how colour is introduced:
- Pre compounded polymers disperse pigment uniformly during initial resin manufacture, preserving the mechanical properties, melt stability, and impact resistance of the base polymer.
- High dosage masterbatch introduces a secondary carrier resin into the barrel, which at higher percentages can alter viscosity, promote polymer degradation, and cause brittleness or sticking.
- Early technical collaboration between your purchasing team, design engineers, and moulding partner helps identify material compatibility risks before full production runs begin.
Need Technical Support with Material Selection or Moulding Challenges?
At CJ Tool & Mouldings, our experienced team combines practical shop floor problem solving with ISO 9001:2015 quality control across our 90T to 320T presses. Whether you are troubleshooting an existing component or specifying materials for a new project, we are here to help.
Visit www.wearecj.co.uk, email hello@wearecj.co.uk, or call 01384 378866 to speak with our engineering team.
